![]() This is now your boot floppy, (minus the CD driver).After copying is complete, copy the autoexec.bat and config.sys files to the floppy.In DOS, at the C: prompt, type SYS A: to copy the system files to the floppy (A: is your floppy drive). ![]() Place a blank floppy into the floppy drive.Always select " Boot with CD-ROM support" so that you can access your CD-ROM drive. Whenever you use the Windows 98 Startup Disk to boot your system, you will be presented with a menu.Label a floppy disk "Windows 98 Startup Disk", insert it into your floppy drive and then click OK.Click the Startup Disk tab and then click Create Disk.Click on the Start menu, point to Settings and select Control Panel.The 3.5" floppy disk containing your DOS CD ROM Drivers, (check your CDROM manufacturer's Web site).Ĭreating a Windows 98 Boot Floppy (Startup Disk).A blank formatted 3.5" high density floppy disk. ![]() You should first make sure you have the following: Creating a boot floppy is straightforward. This will allow you to install from a CD-ROM. If your system does support CD booting then you may skip this page.Your boot floppy will have to contain your CD-ROM device drivers in order for you to have access to your CD-ROM drive. In order to begin setup of the dual-boot system, and you are using an older system that does not support booting from the CDROM them you will need a boot floppy. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |